Coby CSMP142 Manuel d'instructions télécharger pdf (Page 11)

Page 10 Coby Electronics Corporation

www.cobyusa.com Page 11

English

Getting Started

Using the AC Power Supply

Make sure that the voltage of your electrical power supply

corresponds to the voltage indicated by the manufacturer.

If the voltage is incorrect, consult your dealer or service

center.

This unit should be used with 120V or 220V wall

outlets, only. The voltage selector on the bottom

of the unit must be set to the appropriate voltage

before connection.

Connect the electrical cord by plugging it into the wall

outlet. Keep objects clear of the cord where it connects to

the device and to the wall. Do not stretch the cord.

To completely disconnect the device from the electrical

supply, unplug the power cord from the outlet.

For your safety, unplug the device during electrical

storms.

Installing/Replacing the Remote Control Batteries

Your remote control comes with batteries pre-installed.

Remove battery insulator tape before use. Batteries should

be replaced when remote control performance diminishes

or stops.

To replace the batteries:

Open the battery door on the back of the unit. 

Remove the battery door. 

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 87 88

Pas de commentaire

Coby CSMP142 Manuel d'instructions Page 11